Configuration du NTP

NTP: Network Time Protocol 

 Introduction 

 Pour effectuer une synchronisation NTP, il faut tout d'abord que le switch puisse aller sur internet 

 Procurve switch 2650# configure terminal

Procurve switch 2650(config)# vlan 1

Procurve switch 2650(vlan-1)# ip address 192.168.1.100 255.255.255.0

Procurve switch 2650(vlan-1)# exit

Procurve switch 2650(config)# ip default-gateway 192.168.1.1

Procurve switch 2650(config)# 

 Configuration du SNTP 

 Procurve switch 2650(config)# timesync sntp

Procurve switch 2650(config)# sntp server 194.2.0.28

Procurve switch 2650(config)# sntp unicast 

 Vérification 

 Procurve switch 2650# show sntp

SNTP Configuration

	Time Sync Mode: sntp

 SNTP Mode: unicast

 Poll Interval (sec) [720] : 720

 

 IP Address			Protocol Version

 -------------		----------------

 194.2.0.28			3

Procurve switch 2650# show time

Sun Dec 12 10:29:05 2021 

 Configuration du NTP 

 Procurve switch 2650(config)# ip timep manual 194.2.0.58

Procurve switch 2650(config)# timesync timep 

 Vérification 

 Procurve switch 2650# show timep

 Timep Configuration

 	

 Time Sync Mode: Timep

 TimeP Mode [Disabled] : Manual		Server Address : 194.2.0.58

 Poll Interval (min) [720] : 720

Procurve switch 2650# show time

Sun Dec 12 10:37:16 2021 

 Configuration statique 

 ProCurve Switch 2650(config)# time 09:56

Mon Jan 1 09:56:36 1990

ProCurve Switch 2650(config)# time 05/14/2022

Sat May 14 09:56:50 2022